Back fill blades for pipeline and bulk earthmoving applications.
Available for 6 to 40 ton excavators. they have been designed and developed to allow a 360deg. excavator grade and move large areas of earth in more compact areas where there isnt space to use a bulldozer
Lightweight large capacity loading buckets completely from 400HB material for lightness and strength allowing much larger capacity buckets than normal
Available for 13 to 40 ton excavators
Cable buckets are mainly for cable installation applications (fibre optics etc) typically only 80mm (other sizes available) wide but designed to dig to at least 650mm and normally used on 1 to 2 ton excavators
Deep dig buckets available for 1 ton to 13 ton excavators allowing narrow trenches to be dug deeper than a std bucket we can build them to almost any width and depth to suit your need
Our Concrete pouring buckets are available in 2 sizes for 6 to 20 ton excavators. Available with dual fitment brackets for 6 and 13 ton or 13 and 20ton machines to alow full utilisation on site
Clay Spade buckets are designed for digging in clay type sticky applications.
With a more open shape and low sides they allow the clay to be easily emptied from the bucket and not sticking in the sides
Available for 1 to 13 ton excavators
Reed buckets or baskets are for clearing reeds, grass and weeds out of ditches and dykes
Available for 6 to 20 ton machines
We have a range of sweeper brush attachments from 1200mm up to 2450mm wide perfect for sweeping and tidying up yards and sites.
The standard brushes are designed to fit normal forkilft tines
We also offer an adapter that fits in place of the forks so the brushes can be used with 1 to 13 ton excavators
The excavator thumb is a cost effective attachment allowing a standard bucket to be used as a grab.
The thumb can be used for many applications where there is a need to move large items about occasionally, and can be folded up against the dipper when not needed
Available for 1 to 8 ton excavators
The square hole and grave digging buckets have revised shapes to be able to dig square hole faces
We can manufacture a full range of bolt on brackets for hydraulic attachments with over 40 years experience in the design and manufacture of them.
Our brackets are used worldwide by many major OEMs
We supply conversion kits so you can alter a bucket from machine to fit another.
a set comprises of machined bosses, or weld in pins and 2 profiled plates with extra material so they can be cut and shaped to suit any attachment